Gas Line Installation and Repair in San Diego
New gas lines for appliances and outdoor kitchens, leak repair, and pressure testing for a meter turn-on. Every job permitted and tested, because gas is not a place to save a step.
- 24/7, no after-hours upcharge
- One-year labor warranty
- CA License C-36 #1157656

Sound familiar? It is worth a call.
- You are adding a gas range, dryer, fire pit, BBQ, or pool heater
- SDG&E locked the meter after a pressure test failure
- A sulfur smell near an appliance or in the yard
- Converting a tank water heater to tankless and the line is too small
- An old flex connector or corroded black pipe
We run new black iron and CSST gas lines from the meter or an existing manifold to any appliance, sized by BTU load and length so every burner gets full pressure. We locate and repair leaks in buried and in-house lines, replace corroded fittings and appliance connectors, and perform the pressure test SDG&E requires before restoring a locked meter. Outdoor stubs for BBQs and fire pits are the most common install. Every gas job gets a permit and a city inspection under pressure.

Book a site visit. We measure the run, total the BTU load, and check the meter capacity.
Flat quote, permit included.
Install or repair, then a pressure test held for inspection.
City signs off, we connect the appliance and confirm it lights.
What this county does to plumbing.
If SDG&E shut your gas off after a test, the meter stays locked until a licensed plumber isolates the leak, repairs it, and the system holds a pressure test for the inspector. That is the sequence and there is no shortcut. Meter capacity is the other local issue: many homes here have a small meter, and adding a tankless heater plus a pool heater plus an outdoor kitchen can exceed it. We check the meter rating before quoting so the upgrade request to SDG&E, if needed, is part of the plan.
Flat, in writing, before we start.
Quoted flat after the site visit, permit and pressure test included. Leak repair on a locked meter is treated as urgent and quoted the same day. One-year labor warranty.
How Can We Help?
Step 1 of 2Would rather just book a time?
What’s going on?
What Our Customers Are Saying
5.0 · Based on 70 reviews![]()
Answered straight.
I smell gas. What do I do?
Leave the house. Do not flip switches. Call SDG&E from outside, then call us for the repair.
Do I need a permit for a BBQ line?
Yes, in every city we work in. We pull it.
Can you run a line for a tankless heater?
Yes. Most conversions need the line upsized to three-quarter inch.
My meter is locked. How fast can you fix it?
Same day for the diagnosis and repair in most cases. The inspection is scheduled with the city, usually within a day or two.
Black iron or CSST?
Black iron for exposed and underground runs, CSST for tight routing through framing. Both are code-approved and we use each where it fits.
How long does a new appliance line take?
Half a day for most runs, plus the inspection.
Get it handled.
Flat quote before any work starts, one-year labor warranty, and a licensed plumber on the truck.